FeaturesMembershipGuideLog inSign up
Guide

Load

Fatigue level

4 min read

The fatigue level compares what you are training right now with what you are used to. It shows whether a week maintains you, builds you up or overloads you, and gives the ups and downs of your form a yardstick.

Key points

  • The fatigue level is your fatigue (ATL) divided by your fitness (CTL). In the literature it is called the acute:chronic workload ratio, ACWR for short.
  • Around 1 you are training as much as usual. Above it you are building, well above it you are overloading.
  • Whether high values predict injuries is disputed. trace uses the number as a measure of load, not as a forecast.

Acute relative to chronic

Fitness (CTL) is the average of your load over about six weeks, fatigue (ATL) over about one week (Fitness, fatigue and form). Dividing one by the other gives a ratio. At 1.0 you are training exactly as much as in the past weeks on average, at 1.5 half as much again.

The ratio of acute to chronic load was made popular by Tim Gabbett with data from team sports. Injury risk rose when the load of one week was clearly above that of the weeks before, and it was lowest in a middle range of about 0.8 to 1.3. A high chronic load protected rather than harmed (Gabbett, 2016).

How trace calculates it

Gabbett divided the load of the last week by the average of the four weeks before. trace instead divides fatigue by fitness, two moving averages in which older days count less. Williams and colleagues proposed such a calculation with moving averages because it weights the most recent days more than older ones (Williams et al., 2017).

The difference shows after a break. If you divide by the average of the last four weeks, the denominator shrinks with every rest day, and even a normal week afterwards looks like overload. Fitness drops more slowly. That is why a normal week after a break reads as maintaining in trace.

The six ranges

trace divides the fatigue level into six ranges. trace set the boundaries for the calculation with moving averages, based on Gabbett. They sit a little higher than his values, because fitness has a longer memory than a four-week average and a normal build therefore produces higher ratios.

  • Detraining, below 0.5. You are training much less than before. After a race or during a break that is intended, over weeks you lose fitness.
  • Recovery, 0.5 to 0.8. Typical for a deliberate recovery week.
  • Maintaining, 0.8 to 1.1. You are training as much as usual and holding your level.
  • Productive, 1.1 to 1.4. Enough stimulus for adaptation without recovery falling behind.
  • Overreaching, 1.4 to 1.7. Right for a short hard block, over weeks it leads to exhaustion.
  • Critical, from 1.7. Your acute load is far above what your fitness can carry.
Fatigue levelDetrainingRecoveryMaintainingProductiveOverreachingCritical
Example data. The fatigue level of the same example block as in fitness, fatigue and form. In loading weeks it rises into the productive range. In recovery weeks it falls back, but after three loading weeks only into maintaining. Only in the taper does it reach recovery.

A single critical day is no problem, several in a row are a signal to back off. Whether it turns into overtraining is shown better by resting heart rate, HRV and how you feel than by this number (Readiness).

How trace calculates it

  • Fatigue level = fatigue (ATL) ÷ fitness (CTL) on the same day.
  • Above 3 trace no longer shows the exact value, because it says little at that point.
  • If your fitness is still very low, for example with a new account or after a long break, the ratio divides by a very small number. trace still shows the value but never rates it as critical.

Limits

  • Whether the ratio predicts injuries is disputed. Impellizzeri and colleagues consider the existing studies unsuitable for using it to reduce injury risk. They see no physiological rationale for the ratio and point out that such ratios can create statistical artifacts (Impellizzeri et al., 2020).
  • Gabbett's data come from team sports. He himself advises applying the values to individual sport athletes only with caution (Gabbett, 2016).
  • The ratio only knows your load. How well you cope with it also depends on sleep, stress and nutrition.

Next article · 2.4

Monotony, strain and ramp rate

Three values complement fitness, fatigue and form. Monotony and strain show whether your week has enough variety. The ramp rate shows how fast your fitness is growing right now.

2 min read

Related

Load

Fitness, fatigue and form

Recovery and health data

Readiness

Sources

  1. Gabbett, T. J. (2016). The training–injury prevention paradox: Should athletes be training smarter and harder? British Journal of Sports Medicine, 50(5), 273–280. https://doi.org/10.1136/bjsports-2015-095788
  2. Impellizzeri, F. M., McCall, A., Ward, P., Bornn, L., & Coutts, A. J. (2020). Training load and its role in injury prevention, part 2: Conceptual and methodologic pitfalls. Journal of Athletic Training, 55(9), 893–901. https://doi.org/10.4085/1062-6050-501-19
  3. Williams, S., West, S., Cross, M. J., & Stokes, K. A. (2017). Better way to determine the acute:chronic workload ratio? British Journal of Sports Medicine, 51(3), 209–210. https://doi.org/10.1136/bjsports-2016-096589
All sources
Try trace

See your own numbers.

Connect your watch or bike computer, and trace computes fitness, readiness, critical power and durability from your sessions. Starter is free.

Get started freeGet the app

Training analytics for cycling and running.

Product

  • Features
  • Membership
  • Guide
  • Glossary
  • Blog
  • App
  • Log in

Company

  • About
  • Support

Legal

  • Terms & Withdrawal Instructions
  • Privacy
  • Legal Notice
  • Cancel contracts here
  • Withdraw from contract
  • Delete account
© 2026 trace · All rights reserved