FeaturesMembershipGuideLog inSign up
Guide

Load

Fitness, fatigue and form

4 min read

Fitness, fatigue and form describe how your training works over weeks. trace calculates them every day from the load of your sessions. With these three values you can see whether a block is building you up, whether recovery keeps pace and when your legs will be fresh for a race.

Key points

  • Fitness (CTL) is the average of your load over about six weeks, fatigue (ATL) over about one week.
  • Form (TSB) is fitness minus fatigue. It turns negative after hard days and positive after easy ones.
  • A hard block lowers your form first. It only rises once fatigue fades faster than fitness.
  • All three are a model built from your load, not a measurement of your body.

Two responses to every session

Every session leaves two traces. It makes you a little fitter, and it makes you tired. The fatigue is larger at first but fades within one or two weeks. The gain in fitness is smaller and lasts for weeks. Eric Banister and colleagues described this idea as a model in the 1970s. Each session is an impulse to which the body responds with two decaying responses, hence the name impulse-response model (Clarke & Skiba, 2013).

“Performance was calculated as the difference between the positive training effects (PTEs), ascribed to fitness, and the negative training effects (NTEs), ascribed to fatigue”

(Clarke & Skiba, 2013, p. 141)

Fitness (CTL)Fatigue (ATL)
Example data. A single session with 100 points of load, calculated with trace's time constants. Fatigue rises by 13 and has almost faded after two weeks. Fitness rises by just over 2 and lasts for weeks. After about two weeks fitness is above fatigue again and form turns positive.

For your form this means that after a lot of training you are tired first. Fitness only shows once fatigue has faded. That is why form drops during a hard block and rises in an easy week or before a race.

The three values in trace

  • Fitness (CTL) is called chronic training load in the literature. It shows how much training you are used to over weeks.
  • Fatigue (ATL) is called acute training load. It shows what the last few days are taking out of you.
  • Form (TSB) stands for training stress balance and is the difference between the two.
Fitness (CTL)Fatigue (ATL)Form (TSB)
Example data. Twelve weeks of example training, three build weeks and one recovery week in turn, ending with two taper weeks. Fitness rises in steps. Form drops in every build week and rises in the recovery week and the taper.

How to read your form

trace divides form into five ranges. Above +25 it reads “Very fresh”, from +10 to +25 “Fresh”, from −10 to +10 “Balanced”, from −30 to −10 “Loaded” and below that “Overloaded”. trace set these limits itself, they are not the result of a study.

During a build block “Loaded” is normal and intended. Before a race your form should rise. trace's training plan builds this in and lowers the load in the final weeks until the projected form on race day lands in the target range (Tapering).

Form is a balance over weeks. If it is below −30 only because of a single big session, trace says “Acutely fatigued” instead of “Overloaded”. How you are doing today is better described by your readiness and your acute fatigue.

How trace calculates it

  • Today's fitness is 97.65 percent yesterday's fitness and 2.35 percent today's load. For fatigue the split is 86.7 and 13.3 percent. This corresponds to time constants of 42 and 7 days, α = 1 − e^(−1/τ).
  • Form is fitness minus fatigue on the same day, so today's session is already included.
  • A rest day counts as zero load. Both values drop, fatigue faster.
  • The ramp rate is the change in fitness over the last seven days.
  • If your history in trace is still short, trace estimates a starting value so that fitness does not start artificially at zero.

Limits

  • The time constants are the same for everyone. In the original model, they and the weights of fitness and fatigue are estimated for each athlete from their performances (Clarke & Skiba, 2013). trace subtracts fatigue from fitness without weighting.
  • The values are only as good as the load behind them. If a session is missing or your threshold is off, fitness and form are off too.
  • The model only knows load. Sleep, stress and illness go into readiness, not into form.
  • High fitness means a lot of training in recent weeks. How fast you are is shown by critical power and your personal bests.

Next article · 2.3

Fatigue level

The fatigue level compares what you are training right now with what you are used to. It shows whether a week maintains you, builds you up or overloads you, and gives the ups and downs of your form a yardstick.

4 min read

Related

Load

How trace rates a session

Training plan

Tapering

Sources

  1. Clarke, D. C., & Skiba, P. F. (2013). Rationale and resources for teaching the mathematical modeling of athletic training and performance. Advances in Physiology Education, 37(2), 134–152. https://doi.org/10.1152/advan.00078.2011
All sources
Try trace

See your own numbers.

Connect your watch or bike computer, and trace computes fitness, readiness, critical power and durability from your sessions. Starter is free.

Get started freeGet the app

Training analytics for cycling and running.

Product

  • Features
  • Membership
  • Guide
  • Glossary
  • Blog
  • App
  • Log in

Company

  • About
  • Support

Legal

  • Terms & Withdrawal Instructions
  • Privacy
  • Legal Notice
  • Cancel contracts here
  • Withdraw from contract
  • Delete account
© 2026 trace · All rights reserved