FeaturesMembershipGuideLog inSign up
Guide

Performance

Critical power and W'

3 min read

Critical power is the boundary between power you can hold for a long time and power that will exhaust you within a foreseeable time. trace reads it from your best efforts, without you having to do a test.

Key points

  • Below critical power (CP) your metabolism settles at a stable level, above it does not.
  • W' is the work you can do above CP before you are exhausted, a reserve measured in kilojoules.
  • trace calculates both from your power curve, from your best values between 2 and 20 minutes.

A boundary in metabolism

The longer an effort lasts, the less power you can hold. Plotting best power against duration gives a curve that flattens towards long durations and approaches a value. Andrew Jones and Anni Vanhatalo sum it up in one sentence.

“This relationship ‘levels off’ at a ‘critical power’ (CP)”

(Jones & Vanhatalo, 2017, p. S65)

Below this power, lactate, oxygen uptake and the energy stores in the muscle settle at a stable level. Above it they keep changing until you have to stop (Jones & Vanhatalo, 2017). CP thus marks the highest range in which your metabolism stays in balance (Jones et al., 2019). The idea is old. In 1965 Hugues Monod and Jean Scherrer found a similar relationship between power and duration in skeletal muscle and coined the term critical power (Clarke & Skiba, 2013).

W', the reserve above

Above CP you can only do a limited amount of work, the W' (spoken W prime). Whether you use it up on a long climb just above CP or in a short sprint far above it, the amount stays the same, only the rate of use changes (Jones & Vanhatalo, 2017). Below CP W' refills. How that looks over a ride is shown by W'bal.

How trace calculates them

trace takes your best values between 2 and 20 minutes from your power curve. For these efforts work and duration lie almost on a straight line, work = W' + CP × time. The slope of the line is CP, the intercept is W'. For the curve across all durations trace adds a model that also describes short sprints.

No test is needed. It is enough that you went all out a few times over different durations, for example three, five and twelve minutes. The more such efforts there are, the more reliable the values.

Model from CP and W'Best efforts
Example data. An example athlete with a CP of 250 watts and a W' of 20 kilojoules. The curve from both approaches CP as duration grows, the dots are best efforts from training.

CP and FTP

FTP is the power you can hold for about an hour and is often estimated from a 20-minute test. CP and FTP are often in the same neighbourhood but are not the same. CP comes from several efforts and has a physiological meaning as the boundary of the stable range. trace calculates the load of your rides with CP (How trace rates a session) and the zones with the FTP from your profile, if you have entered one.

How trace calculates it

  • CP and W' from the straight line of work against time over your best values between 2 and 20 minutes.
  • The power curve across all durations is described by a model that also includes the peak power of short sprints.

Limits

  • Without hard efforts over several durations the model estimates imprecisely. Long easy rides do not improve CP.
  • The model works best between about 2 and 20 minutes. For very short sprints and very long rides real power deviates from it.
  • When fatigued you no longer reach your CP. How much your power drops after a long ride is shown by durability.

Next article · 4.3

W'bal

W'bal shows second by second how much of your reserve above critical power is left. You see where you went to your limit during a ride and how well you recovered between two surges.

2 min read

Related

Performance

Durability

Performance

Training zones

Sources

  1. Clarke, D. C., & Skiba, P. F. (2013). Rationale and resources for teaching the mathematical modeling of athletic training and performance. Advances in Physiology Education, 37(2), 134–152. https://doi.org/10.1152/advan.00078.2011
  2. Jones, A. M., & Vanhatalo, A. (2017). The ‘critical power’ concept: Applications to sports performance with a focus on intermittent high-intensity exercise. Sports Medicine, 47(Suppl. 1), S65–S78. https://doi.org/10.1007/s40279-017-0688-0
  3. Jones, A. M., Burnley, M., Black, M. I., Poole, D. C., & Vanhatalo, A. (2019). The maximal metabolic steady state: Redefining the ‘gold standard’. Physiological Reports, 7(10), Article e14098. https://doi.org/10.14814/phy2.14098
All sources
Try trace

See your own numbers.

Connect your watch or bike computer, and trace computes fitness, readiness, critical power and durability from your sessions. Starter is free.

Get started freeGet the app

Training analytics for cycling and running.

Product

  • Features
  • Membership
  • Guide
  • Glossary
  • Blog
  • App
  • Log in

Company

  • About
  • Support

Legal

  • Terms & Withdrawal Instructions
  • Privacy
  • Legal Notice
  • Cancel contracts here
  • Withdraw from contract
  • Delete account
© 2026 trace · All rights reserved